Kia Optima Manuals

Kia Sedona: Manifold Absolute Pressure Sensor (MAPS) Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Inspection
1.
Connect the GDS to the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Pressure [kPa (kgf/cm², psi)]
Output Voltage (V) [Ref=5V]
20.0 (0.20, 2.90)
0.79
46.66 (0.47, 6.77)
1.84
101.32 (1.03, 14.7)
4.0

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Disconnect the manifold absolute pressure sensor connector (A).
3.
Remove the mounting bolt (B), and then vertically remove the sensor from the surge tank.

Installation
   
•
Install the component to the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Insert the sensor in the installation hole and be careful not to damage sensor when installing.
1.
Install in the reverse order of removal.
Manifold absolute pressure sensor mounting bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Manifold Absolute Pressure Sensor (MAPS) Schematic Diagrams
Circuit Diagram ...

Intake Air Temperature Sensor (IATS) Specifications
Specification TemperatureResistance (kΩ)°C°F-40-4040.93 ~ 48.35-20-413.89 ~ 16.030325.38 ~ 6.0910503.48 ~ 3.9020682.31 ~ 2.57401041.08 ~ 1.21601400.54 ~ 0.66801760.29 ~ 0.34 ...

Other Information:

Alternator Description and Operation
Description The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage of this ...

Non-operational conditions of parking assist system
Parking assist system may not operate normally when : 1. Moisture is frozen to the sensor. (It will operate normally when moisture melts.) 2. Sensor is covered with foreign matter, such as snow or ...

Categories


Copyright © www.kisedona.com 2016-2024