Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
3. |
Disconnect the solenoid valve connector (A). |
4. |
Measure the resistance between power terminal (5) and signal terminal (17).
|
Replacement |
If a solenoid valve of VFS type needs to be replaced, the
valve body assembly should be replaced and the oil pressure should be
adjusted. If the solenoid valve is replaced individually, it is not
possible to adjust the oil pressure without additional equipment, and if
the oil pressure adjustment procedure is not performed, a shift shock
or delay may occur. |
1. |
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body") |
Don't neglect the interior
Moisture can collect under the floor mats and carpeting and cause corrosion.
Check under the mats periodically to be sure the carpeting is dry. Use particular
care if you carry fertilizers, cleani ...
Trailer towing
If you are considering towing with your vehicle, you should first check with
your country's Department of Motor Vehicles to determine their legal requirements.
Since laws vary the requirements ...