Kia Sedona: Latch Switch Repair procedures - Power Sliding Door System - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Latch Switch Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body Electrical System / Power Sliding Door System / Latch Switch Repair procedures

Inspection
1.
When inspecting, use the inspection equipment to check for input/output values at each position of Power Sliding Door control module.
2.
To check the operation of latch, choose “Power Sliding/Tailgate” menu and vehicle.
3.
Select "Power Sliding Door".
4.
After selecting sensor output, operate the Power Sliding Door in Power Mode and check the voltage of unlatch feedback (in closed mode).
※ Actual voltage may differ from the above figure.
5.
When there’s no change in voltage, replace the latch.
Power Sliding Door (PSD) Control Module Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim [LH]. (Refer to Body - "Luggage Side Trim") 3. Disconnect the power sliding door control module co ...

Power Sliding Door (PSD) Switch Repair procedures
Inspection Overhead Console Door Switch Inspection 1. When inspecting, use the inspection equipment to check for input/output values of Overhead console door switch. If there''s any malfunct ...

Other Information:

Wheel replacement
When replacing the metal wheels for any reason, make sure the new wheels are equivalent to the original factory units in diameter, rim width and offset. A wheel that is not the correct size may adv ...

Oil Pressure Switch Components and Components Location
Components 1. Oil cover2. Oil cover gasket3. Oil pressure switch ...

Categories


Copyright © www.kisedona.com 2016-2024