Kia Optima Manuals

Kia Sedona: Intake Manifold Repair procedures - Intake And Exhaust System - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Intake Manifold Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Mechanical System / Intake And Exhaust System / Intake Manifold Repair procedures

Removal and Installation
1.
Remove the engine cover.
(Refer to Engine and Transaxle Assembly - "Engine Cover")
2.
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
3.
Drain the engine coolant.
(Refer to Cooling System - "Coolant")
4.
Remove the air duct.
(Refer to Intake And Exhaust System - "Air Cleaner")
5.
Remove the battery.
(Refer to Engine Electrical System - "Battery")
6.
Remove the air cleaner assembly.
(Refer to Intake And Exhaust System - "Air Cleaner")
7.
Remove the surge tank.
(Refer to Intake And Exhaust System - "Surge Tank")
8.
Remove the low pressure fuel line.
(Refer to Engine Control / Fuel System - "Fuel Line")
9.
Remove the intake manifold (A).

   
•
Cover the cylinder head intake port with a clean woven stuff or vinyl cover to prevent foreign materials from entering.
•
Otherwise, engine coolant may enter the intake port from the vent holes of the cylinder head causing problems in the engine combustion chambers.
10.
Install in the reverse order of removal.
   
Tighten the intake manifold bolts and nuts, in several passes as below.
Tightening torque
Step 1 : 3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~ 4.3lb-ft)
Step 2 : 26.5 ~ 31.4N.m (2.7~3.2kgf.m, 19.5~23.1lb-ft)
Step 3 : Repeat 2nd step twice or more.

Intake Manifold Components and Components Location
Components 1. Intake manifold ...

Exhaust Manifold Components and Components Location
Components 1. LH Exhaust manifold gasket2. LH Exhaust manifold3. LH Heat protector4. LH Exhaust manifold stay5. RH Exhaust manifold gasket6. RH Exhaust manifold7. RH Heat protector8. RH Exhaust m ...

Other Information:

Ignition Coil Repair procedures
Removal Ignition coil (Cylinder #1) [Bank 1] 1. Remove the surge tank. (Refer to Engine Mechanical System - "Surge Tank") 2. Disconnect the Ignition coil connector (A). 3. Remove the i ...

Center Pillar Trim Repair procedures
Replacement [Center pillar lower trim]     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related ...

Categories


Copyright © www.kisedona.com 2016-2024