Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the intake actuator connector. |
3. |
Verify that the actuator operates to the recirculation position when 12V is connected to terminal 3 and ground to terminal 7.
Verify that the intake actuator operates to the recirculated air position when connected in reverse.
|
4. |
Connect the intake actuator connector. |
5. |
Turn the ignition switch ON. |
6. |
Check the voltage between terminals 5 and 6.
Specification
It will feedback the current position of the actuator to controls. |
7. |
If the intake actuator does not operate well, substitute with a known-good intake actuator and check for proper operation. |
8. |
Replace the intake actuator if it is proved that there is a problem with it. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing") |
3. |
Disconnect the connector (A) and then remove the intake actuator (B) after loosening the mounting screw. |
4. |
Install in the reverse order of removal. |
Power Sliding Door (PSD) Control Module Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage side trim [LH].
(Refer to Body - "Luggage Side Trim")
3.
Disconnect the power sliding door control module co ...
Rear Bumper Cover Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage. ...