Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
3. |
Disconnect the solenoid valve connector (A). |
4. |
Measure the resistance between power terminal (14) and signal terminal (8).
|
Removal |
1. |
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body") |
2. |
Disconnect the input & output speed sensor connector (A). |
3. |
Remove the input & output speed sensor (B) after loosening the bolts.
|
Installation |
1. |
Install in the reverse order of removal.
|
Components and Components Location
Component Location
1. Head lamp leveling actuator (Built-in Head lamp)2. Head lamp leveling unit (Rear right only)
...
Hitches
It's important to have the correct hitch equipment. Crosswinds, large trucks
going by, and rough roads are a few reasons why you ...