Kia Sedona: In-car Sensor (DATC only) Description and Operation - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: In-car Sensor (DATC only) Description and Operation

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / In-car Sensor (DATC only) Description and Operation

Description
The In-car air temperature sensor is built in the heater & A/C control unit.
The sensor consists of a thermistor that measures the inside temperature. The signal decided by the resistance value that changes in accordance with perceived inside temperature, is delivered to heater control unit, and according to this signal, the control unit regulates in-car temperature to intended value.
[AVN Type]

[AUDIO Type]

Evaporator Temperature Sensor Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure resistance between terminals “+” and “-” of the evaporator tempera ...

Photo Sensor Description and Operation
Description The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light r ...

Other Information:

Rail Pressure Sensor (RPS) Repair procedures
Inspection 1. Connect the GDS to the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. Removal 1. Turn the ignition switch OFF and d ...

SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Me ...

Categories


Copyright © www.kisedona.com 2016-2024