Components |
No. | Connecter A | Connecter B | Connecter C | Connecter D |
1 | - | Batt (+) | - | - |
2 | Front tilt motor (Up) | GND | - | Seat rear height sensor |
3 | Rear height motor (Up) | Batt (+) | Slide switch signal (Forward) | - |
4 | Reclining motor (Forward) | - | Reclining switch signal (Forward) | Body CAN (High) |
5 | Slide motor (Forward) | GND | Front tilt switch signal (Up) | Body CAN (Low) |
6 | - |   | Rear height switch signal (Up) | - |
7 | Front tilt motor (Down) | Slide sensor | IGN1 | |
8 | - | Reclinin sensor | Batt (+) | |
9 | - | Front tilt sensor | GND | |
10 | Rear height motor (Down) | Seat position sensor power | - | |
11 | Reclining motor (Backward) | - | - | |
12 | Slide motor (Backward) | - | - | |
13 |   | Slide switch signal (Backward) | - | |
14 | Reclining switch signal (Backward) | - | ||
15 | Front tilt switch signal (Down) | - | ||
16 | Rear height switch signal (Down) | - | ||
17 | - |   | ||
18 | - | |||
19 | - | |||
20 | - |
Anti-Pinch Strip Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the tail gate trim.
(Refer to Body - "Tail Gate Trim")
3.
Disconnect the anti-pinch strip sensor connector (A).
4.
R ...
Accelerator Position Sensor (APS) Schematic Diagrams
Circuit Diagram
...