Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the HO2S connector. |
3. |
Measure resistance between the HO2S terminals 3 and 4. |
4. |
Check that the resistance is within the specification.
|
Removal |
Note that the SST (Part No : 09392-1Y100 or 09392-2H100) is used when removing the heated oxygen sensor. |
[Bank 1/Sensor 1] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the connector (A). |
3. |
Remove the heated oxygen sensor (A). |
[Bank 1/Sensor 2] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the connector (A). |
3. |
Remove the heated oxygen sensor (A). |
[Bank 2/Sensor 1] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the connector (A). |
3. |
Remove the heated oxygen sensor (A). |
[Bank 2/Sensor 2] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the connector (A). |
3. |
Remove the heated oxygen sensor (B). |
Installation |
|
Note that the SST (Part No : 09392-1Y100 or 09392-2H100) is used when removing the heated oxygen sensor. |
1. |
Install in the reverse order of removal.
|
Rear Transverse Trim Components and Components Location
Component Location
1. Rear transverse trim
...
Rear fan speed control
From front seat
Set the rear climate control selection (REAR ON) button to the ON position and
turn the rear fan speed control (REAR) knob in the front climate control panel to
the desired posi ...