Kia Sedona: Fuel Pump Repair procedures - Fuel Delivery System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Fuel Pump Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pump Repair procedures

Inspection
[Fuel pump]
1.
Turn the ignition switch OFF, and then remove battery (-) terminal.
2.
Remove the fuel pump assembly.
(Refer to Fuel Pump - "Removal")
3.
Check that motor operates properly when battery voltage is applied to terminals 4 and 5 of fuel pump connector (A).
Pin No.
Description
1
Fuel sender signal
2
-
3
Fuel sender ground
4
Fuel pump motor (+)
5
Fuel pump motor ground

[Fuel sender]
1.
Turn the ignition switch OFF, and then remove battery (-) terminal.
2.
Remove the fuel pump assembly.
(Refer to Fuel Pump - "Removal")
3.
Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.
Pin No.
Description
1
Fuel sender signal
2
-
3
Fuel sender ground
4
Fuel pump motor (+)
5
Fuel pump motor ground

4.
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
Posion
Resistance (Ω)
Capacity (ℓ)
E
198 ~ 202
7.5
 1/2
98.6 ~ 100.6
42.5
F
7 ~ 9
78.4

Removal
1.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line")
2.
Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
3.
Remove the second row seat LH
(Refer to Body - "Rear Seat Assembly")
4.
Open the floor mat (A).

5.
Remove the fuel pump service cover (A

6.
Disconnect the fuel pump connector (A), fuel tank pressure sensor (B) and fuel feed tube quick-connector (C).

7.
Remove the fuel pump plate cover (B) by using the special service tool (A) [SST NO.:09310-B8100].

8.
Remove the fuel pump (A).

Installation
1.
Install in the reverse order of removal.
   
Be careful of fuel pump direction (Refer to the groove in the fuel tank).

Fuel pump plate cover installation bolt :
2.0 ~ 2.9 N.m (0.2 ~ 0.3 kgf.m, 1.4 ~ 2.2 lb-ft)

Fuel Tank Repair procedures
Removal 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line") 2. Turn the ignition switch OFF and ...

Fuel Filter Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A) and fuel pump connector (B). 3. Remove the cushion pipe fixi ...

Other Information:

SS-A Solenoid Valve(ON/OFF) Schematic Diagrams
Circuit Diagram ...

Walk-out seat (2nd row seat for SXL package)
To get out from the 3rd row seat, 1. Lift the armrest up , lower the headrests to the lowest position and slide the seat inside. (if necessary). 2. Pull the walk-in strap (1) on the 2nd row seat ...

Categories


Copyright © www.kisedona.com 2016-2024