Inspection |
1. |
Turn the ignition switch ON. |
2. |
Manually operate the control switch and measure the voltage of the blower motor. |
3. |
Operate the control switch to raise the voltage up to high speed.
Specification
|
4. |
If the measured voltage is not within specification,
substitute with a known-good field effect transistor and check for
proper operation. |
5. |
Replace the field effect transistor if it is proved that there is a problem with it. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing") |
3. |
Disconnect the connector (A) and then remove the field effect transistor (B) after loosening the mounting screws. |
4. |
Install in the reverse order of removal. |
Front Seat Shield Outer Cover Repair procedures
Replacement
[Front seat shield front cover]
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the re ...
Engine Room Under Cover Components and Components Location
Components
1. Engine room RH side cover2. Engine room LH side cover3. Engine room front under cover
...