Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the evaporator temperature sensor connector. |
3. |
Measure resistance between terminals “+” and “-” of the evaporator temperature sensor.
Specification
|
4. |
Connect the evaporator temperature sensor connector. |
5. |
Run the engine, turn the A/C switch ON, and then measure the voltage between the terminals of the harness connector. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing") |
3. |
Separate the evaporator temperature sensor after rotating it 90° in a counterclockwise direction. |
4. |
Disconnect the evaporator temperature sensor connector (A). |
5. |
Remove the evaporator temperature sensor (A). |
6. |
Install in the reverse order of removal. |
High mounted stop lamp replacement
1. Open the tailgate.
2. Gently remove the center cover of the rear tailgate trim.
3. Disconnect the electrical connector.
4. Loosen the retaining nuts and remove the spoiler.
5. Remove the ...
ESC operation off
ESC OFF state
This car has 2 kinds of ESC off states.
If the engine stops when ESC is off, ESC remains off. Upon restarting the engine,
the ESC will automatically turn on again.
ESC off state 1 ...