Kia Sedona: ETC (Electronic Throttle Control) System Troubleshooting - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: ETC (Electronic Throttle Control) System Troubleshooting

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Troubleshooting

Fail-Safe Mode
Item
Fail-Safe
ETC Motor
Throttle valve stuck at 7°
TPS
TPS 1 fault
ECM looks at TPS2
TPS 2 fault
ECM looks at TPS1
TPS 1,2 fault
Throttle valve stuck at 7°
APS
APS 1 fault
ECM looks at APS 2
APS 2 fault
ECM looks at APS 1
APS 1,2 fault
Engine idle state

   
When throttle value is stuck at 7°, engine speed is limited at below 1,500rpm and vehicle speed at maximum 40 ~ 50 km/h (25 ~ 31 mph).
ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle ...

Barometric Pressure Sensor (BPS) Specifications
Specification Pressure [kPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]10.0 (0.01, 0.15)0.5055.0 (0.56, 7.98)2.21115.0 (1.17, 16.9)4.50 ...

Other Information:

Rear Heater Core Repair procedures
Replacement 1. Disconnect the battery negative terminal. 2. When the engine is cool, drain the engine coolant from the radiator. (Refer to Engine Mechanical System - “Coolant”) 3. Rem ...

Input Speed Sensor Description and Operation
Description • Input speed sensor uses an electric current type hall sensor in which the current is changed by the magnetic variation. • Input speed sensor (A) and output speed ...

Categories


Copyright © www.kisedona.com 2016-2024