Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the ECTS connector. |
3. |
Remove the ECTS (Refer to "Removal"). |
4. |
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4. |
5. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner") |
3. |
Disconnect the engine coolant temperature sensor connector (A). |
4. |
Remove the spring clip (B), and then pull the sensor from the water temperature control assembly.
|
Installation |
|
1. |
Install in the reverse order of removal. |
2. |
Supplement the engine coolant.
(Refer to Engine Mechanical System - "Coolant") |
Description and Operation
Description
The SMART KEY system is a system that allows the user to
access and operate a vehicle in a very convenient way. To access the
vehicle, no traditional key or remote control unit is n ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
Specification
Item SpecificationControl typeN/H (Normal High)Control pressure kpa (kgf/cm², psi)"500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)"Current value (mA)50 ~ 850Coil resistance(Ω)5.1 ± 0.3
...