Removal |
1. |
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”) |
2. |
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”) |
3. |
Remove the remove the both side of band (B) of the dynamic damper (A). |
4. |
Fix the driveshaft (A) with a vice (B) as illustrated. |
5. |
Apply soap powder on the shaft to prevent being damaged
between the shaft spline and the dynamic damper when the dynamic damper
is removed. |
6. |
Seperate the dynamic damper (A) from the shaft (B) carefully. |
Installation |
1. |
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. |
2. |
Install the dynamic damper. |
3. |
Install the dynamic damper band (A). |
4. |
Using the SST(09495-3K000), secure the TJ boot bands (B).
|
5. |
Install the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ joint”) |
6. |
Install the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”) |
7. |
Check the front alignment.
(Refer to Suspension System - "Front Alignment") |
Using a cellular phone or a twoway radio
When a cellular phone is used inside the vehicle, noise may be produced from
the audio system. This does not mean that something is wrong with the audio equipment.
In such a case, try to operate m ...
Malfunction Indicator Lamp (MIL)
This warning light illuminates :
Once you set the ignition switch or Engine Start/Stop Button to the ON position.
- It remains on until the engine is started.
When there is a malfunction wit ...