Kia Sedona: Description and Operation
Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Electrical System / Ignition System / Description and Operation
| Description |
Ignition timing is controlled by the electronic control ignition timing system.
The standard reference ignition timing data for the engine
operating conditions are pre-programmed in the memory of the ECM (Engine
Control Module).
The engine operating conditions (speed, load, warm-up
condition, etc.) are detected by the various sensors. Based on these
sensor signals and the ignition timing data, signals to interrupt the
primary current are sent to the ECM.
The ignition coil is activated, and timing is controlled.
Ignition System
...
Repair procedures
On-vehicle Inspection
Inspect ignition coil assembly and Perform spark test
1.
Check for DTCs.
•
If a DTC is present, perform troubleshooting in accordanc ...
Other Information:
High mounted stop lamp replacement
1. Open the tailgate.
2. Gently remove the center cover of the rear tailgate trim.
3. Disconnect the electrical connector.
4. Loosen the retaining nuts and remove the spoiler.
5. Remove the ...
Condition and operation in the front passenger occupant detection system
*1 : The ODS system uses a field to evaluate a person's size to determine whether
the air bag should deploy. It is possible for a child to be detected and activate
the ODS, thus allowing the ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2024 Owners Manual
- Kia Sedona YP 2014-2024 Service Manual
Copyright В© www.kisedona.com 2016-2024