Kia Sedona: Description and Operation - Restraint - Kia Sedona YP Service ManualKia Sedona: Description and Operation

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Restraint / Description and Operation

Warning Lamp Activation
Warning Lamp Behavior after Ignition On
As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a lamp check.
The lamp shall turn on for 6 seconds during the initialization phase and be turned off afterward.
To alert the driver, the warning lamp shall turn on for 6 seconds and off for one second then on continuously after the operating voltage is applied if any active fault exists.
1.
Active fault or historical fault counter is greater or equal to 10.

2.
Normal or historical fault counter is less than 10.

3.
When turning the ignition switch ON during variant coding (EOL) mode, the airbag warning lamp illuminates and blinks at intervals of 1 second till the coding is completed.
In case the variant coding has successfully completed, the airbag warning lamp will turn on for 6 seconds and then off. Otherwise, the airbag warning lamp will continuously blink at intervals of 1 second.
(1)
In case the variant coding has successfully completed:

(2)
In case the variant coding is not completed:

When there is active fault in airbag system or SRSCM internal fault, the variant coding (EOL) can’t be completed. In this case, perform the variant coding (EOL) procedure again after troubleshooting with the GDS.
SRSCM Independent Warning Lamp Activation
There are certain fault conditions in which the SRSCM cannot function and thus cannot control the operation of the standard warning lamp. In these cases, the standard warning lamp is directly activated by appropriate circuitry that operates independently of the SRSCM. These cases are:
1.
Loss of battery supply to the SRSCM : warning lamp turned on continuously.
2.
Loss of internal operating voltage : warning lamp turned on continuously.
3.
Loss of Microprocessor operation : warning lamp turned on continuously.
4.
SRSCM not connected : warning lamp turned on continuously.
Telltale Lamp Activation
The Telltale Lamp indicates the Passenger Airbag (PAB) enabled and disabled status based on occupant status on passenger seat. If the passenger seat is empty or occupied with a child (or child seat), the Passenger Airbag is disabled and the Telltale Lamp is turned ON to inform the driver that the PAB is disabled.
ODS (Occupant Detection System) will send an unknown status to the SRSCM as a default setting for passenger airbag deployment during the validation period.
After ignition on, telltale lamp will turn on for 4 seconds and turn off for 3 seconds during the initialization phase and be turned ON afterward until receipt of valid enabled message from ODS system.

General Safety Information and Caution
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Carefully observe the instructions described in this manual as mi ...

Repair procedures
Component Replacement After Deployment     Before performing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing relat ...

Other Information:

Align steering wheel
This warning message illuminates if you start the engine when the steering wheel is turned to more than 90 degrees to the left or right. It means that you should turn the steering wheel and ...

Rheostat Schematic Diagrams
Circuit Diagram ...

Categories


Copyright В© www.kisedona.com 2016-2024