Inspection |
Measuring Resistance |
1. |
Disconnect the cruise control switch connector from the control switch. |
2. |
Measure the resistance between terminals on the control switch when each function switch is ON (and switch is depressed).
|
3. |
If not within specification, replace switch.
|
Measuring Voltage |
1. |
Connect the cruise control switch connector to the control switch. |
2. |
Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).
|
3. |
If not within specification, inspect the control switch resistance. |
Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery terminal. |
2. |
Remove the air-bag module from the steering wheel.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring") |
3. |
Release the remote control switch (A) after loosening the screws. |
4. |
Disconnect the remote control switch connector (A). |
Installation |
1. |
Install in the reverse order of removal. |
Snowy or icy conditions
To drive your vehicle in deep snow, it may be necessary to use snow tires on
your tires. If snow tires are needed, it is necessary to select tires equivalent
in size and type of the original equip ...
Seat belts - Front passenger and rear seat 3-point system with combination locking
retractor
To fasten your seat belt :
Combination retractor type seat belts are installed in the rear seat positions
to help accommodate the installation of child restraint systems. Although a combination
r ...