Removal and Installation |
1. |
Disconnect the battery negative terminal. |
2. |
Remove the air duct (A). |
3. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover") |
4. |
Disconnect the hood latch cable (A). |
5. |
Disconnect the horn connector (A) and hood latch connector (B). |
6. |
Remove the radiator upper member assembly (A).
|
7. |
Separate the radiator upper hose (A) from the hose fixing bracket (B). |
8. |
Disconnect the cooling fan connector. |
9. |
Remove the cooling fan mounting bolt.
[LH]
[RH] |
10. |
Remove the cooling fan assembly (A) from the vehicle. |
11. |
Install in the reverse order of removal. |
1. |
Disconnect the wire harness connector (A) and the fan motor connector (B). |
2. |
Remove the resistor (A) from the cooling fan shroud.
|
3. |
Install in the reverse order of removal. |
Disassembly |
1. |
Remove the cooling fan (A) from the cooling fan assembly.
|
2. |
Disconnect the fan motor connector (A) from the resistor. |
3. |
Remove the fan motor (A) from the cooling fan shroud.
|
4. |
Install in the reverse order of removal. |
Transmitter Repair procedures
Inspection
1.
Check that the red light flickers when the door lock or unlock button is pressed on the transmitter.
2.
Remove the battery (A) and check voltage if the red light doesn''t flicker ...
AC Inverter Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear console assembly.
(Refer to Body - "Floor Console Assembly")
3.
Disconnect the AC inverter unit connector (A).
...