Kia Sedona: Cluster Ionizer (DATC only) Description and Operation
Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Cluster Ionizer (DATC only) Description and Operation
| Description |
The cluster ionizer disinfects and decomposes bad smell from
the air conditioner or air inflow. Also, it cleans the inside air of a
vehicle.
When the ignition switch is ON, the ionizer runs "CLEAN" mode and then "ION" mode, switching between both modes.
In the “CLEAN” mode, the cluster ionizer generates negative ions and positive ions to help clean smells from the air.
In the “ION” mode, the cluster ionizer generates negative ions and cleans inside air of a vehicle.
Auto Defogging Sensor (DATC only) Repair procedures
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the auto defogging se ...
Cluster Ionizer (DATC only) Repair procedures
Inspection
1.
Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch.
DisplayFail description00Normal50Cluster ion generator fault
* For diagnostic procedur ...
Other Information:
Barometric Pressure Sensor (BPS) Specifications
Specification
Pressure [kPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]10.0 (0.01, 0.15)0.5055.0 (0.56, 7.98)2.21115.0 (1.17, 16.9)4.50
...
Yaw-rate and G Sensor Description and Operation
Description
The yaw rate and G sensor is included inside the air bag control module (SRSCM).
When the vehicle is turning with respect to a vertical axis
the yaw rate sensor detects the yaw rate ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2024 Owners Manual
- Kia Sedona YP 2014-2024 Service Manual
Copyright © www.kisedona.com 2016-2024