Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the CCV connector. |
3. |
Measure resistance between the CCV terminal 1 and 2. |
4. |
Check that the resistance is within the specification.
|
5. |
Disconnect the vapor hose connected with the canister from the CCV. |
6. |
Connect a vacuum pump to the nipple. |
7. |
Ground the CCV control line and apply battery voltage to the CCV power supply line. |
8. |
Apply vacuum and check the valve operation.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Lift the vehicle. |
3. |
Disconnect the canister close valve connector (A). |
4. |
Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve. |
5. |
Remove the canister close valve (C). |
Installation |
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting. |
1. |
Install in the reverse order of removal. |
Push-starting
Vehicles equipped with automatic transaxle lock system cannot be push-started.
Follow the directions in this section for jump-starting.
WARNING - Tow starting vehicle
Never tow a vehicle to sta ...
Antenna
Your vehicle uses a roof antenna to receive AM or/and FM broadcast signals.
When reinstalling your roof antenna, it is important that it is fully tightened
and adjusted to the upright position to ...