Inspection |
1. |
Check the signal waveform of the CMPS and CKPS using the GDS.
|
Removal |
|
[Bank 1/Intake] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner") |
3. |
Disconnect the camshaft position sensor connector (A). |
4. |
Remove the mounting bolt, and then remove the engine hanger (A). |
5. |
Remove the mounting bolt, and then vertically remove the sensor (A) from the cylinder head cover. |
[Bank 1/Exhaust] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner") |
3. |
Disconnect the camshaft position sensor connector (A). |
4. |
Remove the mounting bolt, and then vertically remove the sensor from the cylinder head cover. |
[Bank 2/Intake] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the camshaft position sensor connector (A). |
3. |
Remove the mounting bolt, and then vertically remove the sensor (B) from the cylinder head cover. |
[Bank 2/Exhaust] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the camshaft position sensor connector (A). |
3. |
Remove the mounting bolt, and then vertically remove the sensor (B) from the cylinder head cover. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Closing the tailgate
To close the tailgate, lower and push down the tailgate firmly. Make sure that
the tailgate is securely latched.
Make sure your hands, feet and other parts of your body are safely out of the
wa ...
Hood Assembly Components and Components Location
Component Location
1. Hood assembly
...