Kia Sedona: Blind Spot Detection Unit Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Unit Repair procedures

Removal

Blind spot detection (BSD) unit

Disconnect the negative (-) battery terminal.

Be careful when removing the blind spot detection unit. The bracket may break off from the bumper.

2.	Remove the rear bumper. (Refer to Body - "Rear Bumper Cover")

3.	Disconnect the BSD connector (A) from the BSD unit.

Remove the BSD assembly (A) after loosening the mounting nuts.

When removing the BSD unit, be careful not to damage the bracket of BSD.

Installation

Blind spot detection (BSD) unit

1.	Place the RH and LH radar sensors on each side to get ready for installation.

Install the radar sensor to the bracket correctly (distinguish RH & LH) with mounting nuts.

The shapes of the LH and RH blind spot detection units are different. Therefore, take notice when installing the blind spot detection units.

Radar Sensors must be closed up against the bracket completely.

After mounting radar sensors, check for a wobble.

3.	Connect the negative (-) battery terminal.

Blind Spot Detection Unit Schematic Diagrams

Circuit Diagram ...

Blind Spot Detection Radar Calibration Description and Operation

Description To correctly sense vehicles on the neighboring lanes using the radar, the direction of the sensor and the direction of the vehicle must be aligned. This is the BSD unit alignment. ...

Other Information:

Front Pillar Trim Components and Components Location
Component Location 1. Front pillar trim ...

Audio Remote Control Components and Components Location
Components 1. Left Remote Control Switch2. Right Remote Control Switch ...

Kia Sedona: Blind Spot Detection Unit Repair procedures

Blind Spot Detection Unit Schematic Diagrams

Blind Spot Detection Radar Calibration Description and Operation

Other Information:

Categories