Kia Sedona: Blind Spot Detection Radar Calibration Description and Operation
Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Radar Calibration Description and Operation
| Description |
To correctly sense vehicles on the neighboring lanes using
the radar, the direction of the sensor and the direction of the vehicle
must be aligned.
This is the BSD unit alignment. If this alignment is not
performed as in illustration below, it may cause degradation of
detection performance and false alarms.
In particular, rear bumper accident vehicles and vehicles that replaced BSD unit must carry out this alignment procedure.
| 1. |
Rear bumper accident vehicles and vehicles that replaced BSD units must perform BSD unit alignment using GDS. |
| 2. |
Select "BSD Radar Calibration" procedure in BSD system.
|
| 3. |
Perform the "BSD Radar Calibration" procedure according to the GDS screen message.
|
Blind Spot Detection Unit Repair procedures
Removal
Blind spot detection (BSD) unit
1.
Disconnect the negative (-) battery terminal.
Be careful when removing the blind spot detection unit. The bracket may brea ...
Other Information:
3 Point rear center belt (for 2nd and/ 3rd center seat)
To fasten the rear center belt
1. Pull out the mini tongue from hole on the belt assembly cover (1) and then
slowly pull the seat belt out from the retractor.
2. Pull out the tongue plate from ...
Recommended engine coolant
When adding coolant, use only deionized water or soft water for your vehicle
and never mix hard water in the coolant filled at the factory. An improper coolant
mixture can result in serious m ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2024 Owners Manual
- Kia Sedona YP 2014-2024 Service Manual
Copyright В© www.kisedona.com 2016-2024