Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the mirror (A) from the mirror holder.
|
3. |
Disconnect the heater connector (A) from mirror assembly. |
4. |
Remove the BSD warning lamp (A). |
Installation |
1. |
Install the BSD warning lamp and mirror. |
2. |
Connect the mirror heater connector. |
3. |
Connect the negative (-) battery terminal. |
Inspection |
1. |
Verify that the mirror operates properly as shown in the below table.
BSD warning lamp |
Air Cleaner Filter Repair procedures
Inspection
1.
Remove the air cleaner element.
2.
Check that the air filter is excessively dirty.
If the air filter is excessively dirty, replace the air cleaner element.
3.
If the air cl ...
Intake Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the actuator operates to the recirculation position when 12V is connected to termina ...