Kia Sedona: BJ Boot Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Repair procedures

Removal

1.	Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”)

2.	Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”)

3.	Remove the Dynamic damper. (Refer to Driveshaft Assembly - “Dynamic Damper”)

4.	Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.	Remove the BJ boot.

Install in the reverse order of removal.

•	Do not disassemble the BJ assembly.

•	Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.

•	The boot band should be replaced with a new one.

7.	Check the front alignment. (Refer to Suspension System - "Front Alignment")

BJ Boot Components and Components Location

Components 1. BJ assembly2. BJ circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Retainer ring12. TJ housing13. Housin ...

Front Axle Assembly

...

Other Information:

Engine Oil Pressure Warning Light
This warning light illuminates : Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When the engine oil pressure is ...

Special Service Tools
Special Service Tools Tool (Number and name)IllustrationUse09880-4F000Hog ring clip installerHog ring clip installation ...

Kia Sedona: BJ Boot Repair procedures

BJ Boot Components and Components Location

Front Axle Assembly

Other Information:

Categories