Kia Sedona: Barometric Pressure Sensor (BPS) Description and Operation
Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Barometric Pressure Sensor (BPS) Description and Operation
| Description |
Barometric Pressure Sensor (BPS) is a speed-density type
sensor and is installed on the air cleaner assemby. It senses absolute
pressure of the air cleaner assemby and transfers the analog signal
proportional to the pressure to the ECM. By using this signal, the ECM
calculates the intake air quantity and engine speed.
The BPS consists of a piezo-electric element and a hybrid IC
that amplifies the element output signal. The element is silicon
diaphragm type and adapts pressure sensitive variable resistor effect of
semi-conductor. Because one end of the silicon diaphragm is 100% vacuum
and the manifold pressure applies to the other end, the sensor output
can be achieved in analog signals from the silicon variation
proportional to pressure change.
Barometric Pressure Sensor (BPS) Specifications
Specification
Pressure [kPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]10.0 (0.01, 0.15)0.5055.0 (0.56, 7.98)2.21115.0 (1.17, 16.9)4.50
...
Barometric Pressure Sensor (BPS) Schematic Diagrams
Circuit Diagram
...
Other Information:
Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage. ...
Blind Spot Detection Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the crash pad lower switch (A) after loos ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2024 Owners Manual
- Kia Sedona YP 2014-2024 Service Manual
Copyright © www.kisedona.com 2016-2024