Kia Sedona: Auto Defogging Sensor (DATC only) Repair procedures
Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Auto Defogging Sensor (DATC only) Repair procedures
| Inspection |
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the auto defogging sensor cover (A).
|
| 3. |
Remove the auto defogging sensor (A) after disconnecting the auto defogging sensor connector (B).
|
| 4. |
Install in the reverse order of removal. |
Auto Defogging Sensor (DATC only) Description and Operation
Description
The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal to blow out wind for defogging
if moisture occurs. On receiving the signal from ...
Cluster Ionizer (DATC only) Description and Operation
Description
The cluster ionizer disinfects and decomposes bad smell from
the air conditioner or air inflow. Also, it cleans the inside air of a
vehicle.
When the ignition switch is ON, the ion ...
Other Information:
Surround View Monitoring Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the instrument cluster.
(Refer to Indicators And Gauges - "Instrument Cluster")
3.
Loosen the mounting screws from backw ...
Barometric Pressure Sensor (BPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the BPS at idle and IG ON.
Pressure [kPa (kgf/cmВІ, psi)]Output Voltage (V) [Ref=5V]10.0 (0. ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2024 Owners Manual
- Kia Sedona YP 2014-2024 Service Manual
Copyright В© www.kisedona.com 2016-2024