Kia Sedona: Alternator Description and Operation
Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Electrical System / Charging System / Alternator Description and Operation
| Description |
The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal.
In addition, the charging voltage of this alternator is regulated by the battery voltage detection system.
The alternator is regulated by the battery voltage detection system.
The main components of the alternator are the rotor, stator, rectifier, capacitor brushes, bearings and V-ribbed belt pulley.
The brush holder contains a built-in electronic voltage regulator.
| 1. Brush 2. Drive belt pully 3. Rotor 4. Stator |
Alternator Specifications
Specification
ItemSpecificationRated voltage13.5V , 150ASpeed in use1,500 ~ 18,000rpmVoltage regulatorIC Regulator built in typeDefault regulated voltage (V) [COM terminal]14.0 ~ 15.5 (-35°C)14. ...
Alternator Schematic Diagrams
Circuit Diagram
•
COM signal - When
controlling the voltage generated, the ECM sends the target voltage data
to the alternator via a PWM signal (High volta ...
Other Information:
Noise and smoke
When inflated, the air bags make a loud noise and leave smoke and powder in the
air inside the vehicle. This is normal and is a result of the ignition of the air
bag inflator. After the air bag in ...
Rear Door Latch Repair procedures
Replacement
[Front]
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Disconnect the rear door cable (A).
3.
Disconnect the rear door remote controller connector ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2024 Owners Manual
- Kia Sedona YP 2014-2024 Service Manual
Copyright © www.kisedona.com 2016-2024