Kia Sedona: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
| 3. |
Disconnect the solenoid valve connector (A).
|
| 4. |
Measure the resistance between power terminal (5) and signal terminal (16).
|
| Replacement |
If a solenoid valve of VFS type needs to be replaced, the
valve body assembly should be replaced and the oil pressure should be
adjusted. If the solenoid valve is replaced individually, it is not
possible to adjust the oil pressure without additional equipment, and if
the oil pressure adjustment procedure is not performed, a shift shock
or delay may occur. |
| 1. |
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body") |
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Schematic Diagrams
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) SpecificationsEngine number
The engine number is stamped on the engine block as shown in the drawing. ...
Installing the tumble seat (for 8 passenger vehicle)
1. Put the front anchor strikers along the front anchors on the floor.
2. Insert two front anchor strikers into the front anchors.
3. Lift the rear portion of the seat cushion then push down fir ...