Kia Sedona: Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sedona YP Service ManualKia Sedona: Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications

Specification
Item
Specification
Control type
N/L (Normal Low)
Control pressure kpa (kgf/cm², psi)
"9.81 ~ 500.14
(0.1 ~ 5.1, 1.42 ~ 72.54)"
Current value (mA)
50 ~ 850
Coil resistance(Ω)
5.1 ± 0.3

Output Speed Sensor Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. M ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Components and Components Location
Component Location 1. Torque Converter Control Solenoid Valve (T/CON_VFS) ...

Other Information:

Inhibitor Switch Repair procedures
Inspection Power Circuit Inspection 1. Disconnect the Inhibitor switch connector. 2. Ignition KEY "ON"" & Engine "OFF".. 3. Measure voltage between supplied power and ground at inhi ...

Troubleshooting
Troubleshooting Ignition System Trouble symptomProbable causeRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as required ...

Categories


Copyright © www.kisedona.com 2016-2025