Kia Sedona: Sliding the sunroof - Sunroof - Features of your vehicle - Kia Sedona YP Owners ManualKia Sedona: Sliding the sunroof

Third generation YP (2014-2024) / Kia Sedona YP Owners Manual / Features of your vehicle / Sunroof / Sliding the sunroof

To open the sunroof, pull the sunroof control lever backward.

To close the sunroof, push the sunroof control lever forward.

To open the sunroof automatically :

Pull the sunroof control lever backward to the second detent position and then release it.

The sunroof will open as below :

- Front sunroof : sunroof will slide all the way open.
- Rear sunroof : sunroof will not open fully.

To open the sun roof fully, pull the sunroof control lever again.

To stop the sunroof sliding at any point, pull or push the sunroof control lever momentarily.

To close the sunroof automatically :

Pull the sunroof control lever backward to the second detent position and then release it. The sunroof will slide all the way open.

To stop the sunroof sliding at any point, pull or push the sunroof control lever momentarily.

While driving with the sunroof in an open (or partially open position), your vehicle may demonstrate a wind buffeting or pulsation noise. This noise is a normal occurrence and can be reduced or eliminated by taking the following actions. If you experience the noise with the sunroof open, slightly reduce the size of the sunroof opening.

Sunroof
Front Rear If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The sunroof can only be opened, close ...

Automatic reversal
If an object or part of the body is detected while the sunroof is closing automatically, it will reverse direction, and then stop. The auto reverse function does not work if a tiny obstacle is be ...

Other Information:

Seat height (for driver
To change the height of the seat, push the lever upwards or downwards. To lower the seat cushion, push the lever down several times. To raise the seat cushion, pull the lever up several times. ...

Battery Sensor Repair procedures
Removal 1. Turn the ignition switch OFF. 2. Disconnect the battery negative (-) terminal (A). Battery negative (-) terminal tightening nut : 4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft ...

Categories


Copyright В© www.kisedona.com 2016-2024