Kia Optima Manuals

Kia Sedona: Side Airbag (SAB) Module Repair procedures - Airbag Module - Restraint - Kia Sedona YP Service ManualKia Sedona: Side Airbag (SAB) Module Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Restraint / Airbag Module / Side Airbag (SAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least 30 seconds before beginning to work.
2.
Remove the front seat assembly.
(Refer to Body - "Front seat assembly")
3.
Remove the seat back assembly.
   
The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the side airbag.
Installation
   
When installing the harness wires, be sure that they are not pinched or interfering with other parts.
   
•
Do not open the lid of the side airbag cover.
•
Make sure that the airbag assembly cover is installed properly. Improper installation may hinder proper deployment.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Install the new seat back assembly.
4.
Install the front seat assembly.
(Refer to Body - "Front seat assembly")
5.
Fully recline and slide the front seat forward, and make sure that the harness wires are not pinched or interfering with other parts.
6.
Reconnect the battery negative cable.
7.
After installing the side airbag (SAB), confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Side Airbag (SAB) Module Components and Components Location
Components ...

Curtain Airbag (CAB) Module Description and Operation
Description Curtain airbags are installed inside the headliner (LH and RH) to protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain air ...

Other Information:

BJ Boot Repair procedures
Removal 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”) 3. Rem ...

Description and Operation
Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a lamp check. T ...

Categories

Copyright © www.kisedona.com 2016-2026