- The ignition key is in the ignition switch.
- You exceed the operating distance limit (about 10 m [30 feet]).
- The battery in the transmitter is weak.
- Other vehicles or objects may be blocking the signal.
- The weather is extremely cold.
- The transmitter is close to a radio transmitter such as a radio substation or
an airport which can interfere with normal operation of the transmitter.
CAUTION
Keep the transmitter away from water or any liquid as it can become damaged and not function properly.
✽ NOTICE
If the keyless entry system is inoperative due to exposure to water or liquids,
it will not be covered by your manufacturer Smart key Diagnostic Repair procedures Key not in vehicle (for smart key system)
The horn sounds and hazard warning lights flash for about 27 seconds if this
button is pressed for more than 0.5 second. To stop the horn and lights, press any
button on the transmitter. ...
Panic
The transmitter uses a 3 volt lithium battery which will normally last for several
years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gentl ...
Battery replacement
Other Information:
Inspection
Self Diagnosis With Scan Tool
Using the GDS, it can quickly diagnose defects of SMART KEY
system. GDS can operate actuator forcefully, monitor input/output values
and perform self d ...
This warning message illuminates if the smart key is not in the vehicle
when you press the Engine Start/Stop Button.
It means that you should always have the smart key with you.
...