Kia Sedona: Fuel Tank Pressure Sensor (FTPS) Specifications - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Fuel Tank Pressure Sensor (FTPS) Specifications

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Tank Pressure Sensor (FTPS) Specifications

Specification
Item
Specification
Supply Voltage (V)
5
Operation Voltage (V)
4.75 ~ 5.25

Pressure [kPa (kgf/cm², psi)]
Output Voltage (V) [Ref=5V]
-6.67 (-0.06, -0.97)
0.5
0
2.5
+6.67 (0.068, 0.97)
4.5

Accelerator Position Sensor (APS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T. AcceleratorPositionOut ...

Fuel Tank Pressure Sensor (FTPS) Description and Operation
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge con ...

Other Information:

Front Lower Arm Repair procedures
Removal 1. Remove the front wheel and tire (A) from the front hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to d ...

Rear mode selection
Front climate control is : Rear air blows from the upper vents on the rear ceiling. Front climate control is : Rear air blows from the upper vents on the rear ceiling and the lower vents ...

Categories

Copyright © www.kisedona.com 2016-2026