Kia Sedona: Smart Cruise Control Switch Repair procedures - Smart Cruise Control System - Engine Electrical System - Kia Sedona YP Service ManualKia Sedona: Smart Cruise Control Switch Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Engine Electrical System / Smart Cruise Control System / Smart Cruise Control Switch Repair procedures

Inspection
Measuring Resistance
1.
Disconnect the cruise control switch connector from the control switch.
2.
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Function switch
Terminal
Resistance (kΩ)
[± 5%]
CANCEL
2 - 3
0.56
SET -
2 - 3
0.89
RES +
2 - 3
1.45
CRUISE
2 - 3
2.55
SCC
2 - 3
5.55

3.
If not within specification, replace switch.
Measuring Voltage
1.
Connect the cruise control switch connector to the control switch.
2.
Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).
Function switch
Terminal
Voltage (V)
[Vref = 5V]
CANCEL
2 - 3
1.8 ± 0.22
SET -
2 - 3
2.3 ± 0.22
RES +
2 - 3
3.0 ± 0.22
CRUISE
2 - 3
3.5 ± 0.22
SCC
2 - 3
4.2 ± 0.22

3.
If not within specification, inspect the control switch resistance.
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery terminal.
2.
Remove the air-bag module from the steering wheel.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
3.
Release the remote control switch (A) after loosening the screws.

4.
Disconnect the remote control switch connector (A).

Installation
1.
Install in the reverse order of removal.
Smart Cruise Control Switch Schematic Diagrams
Circuit Diagram ...

Starting System
...

Other Information:

Armed stage
Park the vehicle and stop the engine. Arm the system as described below. 1. Remove the ignition key from the ignition switch and exit the vehicle. 2. Make sure that all doors (and tailgate) and engi ...

Rear Assist Arm Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to damage ...

Categories


Copyright © www.kisedona.com 2016-2025