Kia Optima Manuals

Kia Sedona: Oil Pump Repair procedures - Lubrication System - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Oil Pump Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Engine Mechanical System / Lubrication System / Oil Pump Repair procedures

Removal and Installation
1.
Drain engine oil.
(Refer to Lubrication System - "Engine Oil")
2.
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
3.
Remove the lower oil pan.
(Refer to Lubrication System - "Oil Pan")
4.
Remove the oil pump chain cover (A).
Tightening torque :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

5.
Remove the bolt (A) and then separate the chain with sprocket from the oil pump.
Tightening torque :
18.6 ~ 21.6N.m (1.9 ~ 2.2kgf.m, 13.7 ~ 15.9lb-ft)

6.
Remove the oil pump (A).
Tightening torque :
20.6 ~ 22.6N.m (2.1 ~ 2.3kgf.m, 15.2 ~ 16.6lb-ft)

   
When installing, use a new O-ring.
7.
Install in the reverse order of removal.
8.
After assembly, wait for at least 30 minutes before filling the engine with oil.
Oil Pump Components and Components Location
Components 1. Oil pump2. O-ring3. Oil pump sprocket4. Oil pump chain cover ...

Oil Pressure Switch Components and Components Location
Components 1. Oil cover2. Oil cover gasket3. Oil pressure switch ...

Other Information:

Repair procedures
Removal     Put on gloves to protect your hands.     Use seat covers to avoid damaging any surfaces. 1. Remove the front pillar trim. (Re ...

Air bag Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 6 seconds and then goes off. When there is ...

Categories


Copyright В© www.kisedona.com 2016-2025