Kia Sedona: Water Temperature Control Assembly Components and Components Location - Cooling System - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Water Temperature Control Assembly Components and Components Location

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Components and Components Location

Components

1. Water pipe
2. Throttle body coolant hose & pipe
3. Water temperature control assembly
4. O-ring

Reservoir Tank Repair procedures
Removal and Installation 1. Disconnect the over flow hose (A), and then drain the coolant from the reservoir tank. 2. Remove the reservoir tank (B). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ...

Water Temperature Control Assembly Repair procedures
Removal and Installation     To avoid damage, unplug the wiring connectors carefully while holding the connector portion.     Mark all wiring a ...

Other Information:

Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams
Circuit Diagram ...

3 Point rear center belt (for 2nd and/ 3rd center seat)
To fasten the rear center belt 1. Pull out the mini tongue from hole on the belt assembly cover (1) and then slowly pull the seat belt out from the retractor. 2. Pull out the tongue plate from ...

Categories


Copyright В© www.kisedona.com 2016-2025