To fasten the rear center belt
1. Pull out the mini tongue from hole on the belt assembly cover (1) and then slowly pull the seat belt out from the retractor.
2. Pull out the tongue plate from the holder on the seat belt (2).
3. Insert the mini tongue (A) into the open end of the anchor connector (C) until an audible
Cruise Control Switch Repair procedures
Inspection
Measuring Resistance
1.
Disconnect the cruise control switch connector from the control switch.
2.
Measure the resistance between terminals on the control switch when each funct ...
Schematic Diagrams
Circuit Diagram
Connector Pin Information
No.Motor ConnectorSunroof Wiring Connector1Battery 1GND 12Open alarmRear lock switch3GND 1IGN4Rear lock switchSignal C5-Signal A6Signal CBattery 17Signa ...