Kia Sedona: Detecting sensor - BSD (Blind Spot Detection) / LCA (Lane Change Assist) - Blind spot detection system (BSD) - Driving your vehicle - Kia Sedona YP Owners ManualKia Sedona: Detecting sensor

Third generation YP (2014-2026) / Kia Sedona YP Owners Manual / Driving your vehicle / Blind spot detection system (BSD) / BSD (Blind Spot Detection) / LCA (Lane Change Assist) / Detecting sensor

The sensors are located inside of the rear bumper.

Always keep the rear bumper clean for the system to work properly.

Warning type
The system will activate when: 1.The system is on. 2.Vehicle speed is above 30 km/h (18.6 mph ). 3.Other vehicles are detected in the rear side. WARNING The Blind Spot Detection System with L ...

Warning message
Type B Type C The message will appear to notify the driver there are foreign substances on the rear bumper or it is hot near the rear bumper. The light on the switch and the system will turn ...

Other Information:

Manual climate control system
1. Turn the ignition switch to the ON position. 2. Turn the fan speed control knob to the OFF (0) position. 3. Turn the mode selection knob to the defrost position (). 4. Push the air intake cont ...

On inclines
During uphill or downhill driving, the SCC may not detect a moving vehicle in your lane, and cause your vehicle to accelerate to the set speed. Also, the vehicle speed will rapidly slow dow ...

Categories

Copyright © www.kisedona.com 2016-2026