Kia Sedona: Reprogramming a single HomeLink button
To program a device to HomeLink using a HomeLink button previously trained, follow these steps:
1. Press and hold the desired HomeLink button. Do NOT release until step 4 has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 2-8 cm (1 to 3 inches) away from the HomeLink surface.
3. Press and hold the hand-held transmitter button (or press and
Erasing programmed HomeLink buttons
To erase the three programmed buttons (individual buttons cannot be erased) :
...
Canadian Programming Garage & gate openers
During programming, your hand-held transmitter may automatically stop transmitting.
Continue to press and hold the HomeLink button (note steps 2 through 4 in the ...
Other Information:
Front Door Inside Handle Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door inside handle cage (A).
3.
Loosen the screw and remove the IMS switch.
4. ...
Lane departure warning system (LDWS)
This system detects the lane with a sensor at the front windshield and notifies
you if it detects that your vehicle leaves the lane.
WARNING - LDWS Alert
The LDWS is only intended to pro ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2025 Owners Manual
- Kia Sedona YP 2014-2025 Service Manual