Inspection |
1. |
Remove the cowl top cover.
(Refer to Body - "Cowl Top Cover") |
2. |
Disconnect the windshield deicer connector (A). |
3. |
Check for continuity between the terminals of deicer lines. |
4. |
Turn the ignition switch ON and the windshield deicer switch
ON, then measure the voltage between the terminals of harness side
deicer connector.
|
Heated Oxygen Sensor (HO2S) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 3 and 4.
4.
Check that the resistance is within the speci ...
3 Point rear center belt (for 2nd and/ 3rd center seat)
To fasten the rear center belt
1. Pull out the mini tongue from hole on the belt assembly cover (1) and then
slowly pull the seat belt out from the retractor.
2. Pull out the tongue plate from ...