Kia Sedona: Latch Switch Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Power Sliding Door System / Latch Switch Repair procedures
| Inspection |
| 1. |
When inspecting, use the inspection equipment to check for
input/output values at each position of Power Sliding Door control
module. |
| 2. |
To check the operation of latch, choose “Power Sliding/Tailgate” menu and vehicle. |
| 3. |
Select "Power Sliding Door". |
| 4. |
After selecting sensor output, operate the Power Sliding Door
in Power Mode and check the voltage of unlatch feedback (in closed
mode).
※ Actual voltage may differ from the above figure. |
| 5. |
When there’s no change in voltage, replace the latch. |
Power Sliding Door (PSD) Control Module Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage side trim [LH].
(Refer to Body - "Luggage Side Trim")
3.
Disconnect the power sliding door control module co ...
Power Sliding Door (PSD) Switch Repair procedures
Inspection
Overhead Console Door Switch Inspection
1.
When inspecting, use the inspection equipment to check for
input/output values of Overhead console door switch. If there''s any
malfunct ...
Other Information:
Power tailgate non-opening conditions
The power tailgate will not open automatically, but will close under the following
conditions.
When the ignition switch is in the ON position,
1. Vehicle is moving above 3 km/h (2 mph).
2. The ge ...
Shift Lever Repair procedures
Removal
1.
Move the shift lever to "N" range.
2.
Disconnect the battery negative (-) cable.
3.
Remove the knob (A) and boots (B) by pulling them in the
direction of the arrow after separ ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026