Kia Sedona: Rear combination lamp Repair procedures - Lighting System - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Rear combination lamp Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Lighting System / Rear combination lamp Repair procedures

Removal
Rear Combination Lamp (Outside)
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the rear combination lamp cover (A).

3.
Remove the rear combination lamp (A) after loosening the mounting screws.

4.
Disconnect the rear combination lamp connector (A).

Bulb Replacement
1.
Remove the rear combination lamp.
2.
Remove the turn signal lamp bulb (B) by turning the socket (A) counterclockwise.

Rear Combination Lamp (Inside)
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear combination lamp cover (A).

3.
Disconnect the rear combination lamp connector (A).

4.
Remove the rear combination lamp (A) after loosening the mounting nuts.

Bulb Replacement
1.
Remove the rear combination lamp cover.
2.
Remove the stop/tail lamp (B) by turning the socket (A) counterclockwise.

Installation
Rear Combination Lamp (Outside)
1.
Connect the rear combination lamp connector.
2.
Install the rear combination lamp.
3.
Install the rear combination lamp cover.
4.
Connect the negative (-) battery terminal.
Rear Combination Lamp (Inside)
1.
Install the rear combination lamp.
2.
Connect the rear combination lamp connector.
3.
Install the rear combination lamp cover.
4.
Connect the negative (-) battery terminal.
High Mounted stop lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear spoiler. (Refer to Body - "Rear Spoiler") 3. Remove the high mounted stop lamp assembly (A) after loosening nut ...

Troubleshooting
Troubleshooting SymptomPossible causeRemedyOnly one lamp lights on(All exterior lamps)Bulb burned outReplace bulbSocket, wiring or ground faultyRepair if necessaryHead lamps do not light onBulb b ...

Other Information:

ON
Redish orange Press the ENGINE START/STOP button while it is in the ACC position without depressing the brake pedal. The warning lights can be checked before the engine is started. Do not leave ...

Power Steering Gear Box Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to damag ...

Categories

Copyright © www.kisedona.com 2016-2026