Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
3. |
Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw. |
Installation |
1. |
Install the coil antenna and connect the 6P connector. |
2. |
Install the crash pad lower panel. |
3. |
Connect the negative (-) battery terminal. |
Photo Sensor Description and Operation
Description
The photo sensor is located at the center of the defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to
sunlight) diode. The solar radiation received by its light r ...
Rear Upper Arm Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damage ...