Kia Sedona: Blind Spot Detection Indicator Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Indicator Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the mirror (A) from the mirror holder.
|
| 3. |
Disconnect the heater connector (A) from mirror assembly.
|
| 4. |
Remove the BSD warning lamp (A).
|
| Installation |
| 1. |
Install the BSD warning lamp and mirror. |
| 2. |
Connect the mirror heater connector. |
| 3. |
Connect the negative (-) battery terminal. |
| Inspection |
| 1. |
Verify that the mirror operates properly as shown in the below table.
BSD warning lamp
|
Troubleshooting
Troubleshooting
Examples of False-Alarm Occurrence from system characteristics (not considered as problem)
–
Characteristics of EM Wave : EM Waves are reflected against
all materials an ...
Other Information:
Keep paint and trim in good condition
Scratches or chips in the finish should be covered with "touch-up" paint as soon
as possible to reduce the possibility of corrosion. If bare metal is showing through,
the attention of a ...
Hood Insulator Pad Repair procedures
Replacement
1.
Using a clip remover, detach the clips, and remove the hood insulator pad (A).
•
Be careful not to scratch the hood panel.
2.
Install ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026