Kia Sedona: Blind Spot Detection Switch Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel")

3.	Remove the crash pad lower switch (A) after loosening the mounting screws.

4.	Disconnect the connector (A) from the crash pad lower switch.

Installation

1.	Connect the crash pad lower switch connector.

2.	Install the crash pad lower switch and crash pad lower panel.

3.	Connect the negative (-) battery terminal.

Inspection

1.	Disconnect the BSD switch connector from the crash pad lower switch assembly.

2.	Operate the BSD switch, then check for continuity between terminals BSD switch connector.

Circuit Diagram ...

Components ...

Heater & A/C Control Unit (Rear) Components and Components Location
Components (1) [Standard] Connector Pin Function Connector Pin NoFunctionA1BATT2ILL+ (TAIL)3MODE ACT''R F/B - REAR4MODE ACT''R (VENT) - REAR5MODE ACT''R (FLOOR) - REAR6TEMP ACT''R F/B - ...

Categories