Kia Sedona: Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Blind Spot Detection System / Repair procedures
| Diagnosis With GDS |
| 1. |
BSD system defects can be quickly diagnosed by the GDS. GDS
quickly operates actuator to monitor input/output values and to
self-diagnose. |
| 2. |
Connect the cable of GDS to the data link connector on driver side crash pad lower panel, and turn the power on GDS. |
| 3. |
Select the vehicle model and then BSD system. |
| 4. |
Select "Current Data", if you want to check current data of BSD system.
|
| 5. |
If you want to check each module operation forcefully, select "Actuation test".
|
Description and Operation
Description
BSD system uses two magnetic wave radar sensors attached on
the rear panel to measure the distance from the following vehicles and
provide sensing and (visual and auditory) alarms f ...
Other Information:
Repair procedures
Inspection
1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Inspect the PCV valve operation.
(1)
Run the ...
Compressor Repair procedures
Removal
1.
If the compressor is marginally operable, run the engine at
idle speed, and let the air conditioning work for a few minutes, then
shut the engine off.
2.
Disconnect the negative ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026