Kia Optima Manuals

Kia Sedona: Front Seat Back Cover Repair procedures - Front Seat - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Front Seat Back Cover Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Back Cover Repair procedures

Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the front seat shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover")
3.
Remove the front seat shield inner cover.
(Refer to Front Seat - "Front Seat Shield Inner Cover")
4.
Push the lock pin (B) and then pull out the front seat headrest (A).

5.
Push the lock pins (B) from the front seat back board (A), then remove the back board.
   
•
Using a flat head screwdriver, push the center of the clip.
•
Be careful not to damage the lock pins.

6.
Remove the front seat lower protector (A).

7.
Push the lock pin, then disconnect the front seat back duct lower (A).

8.
Remove the front seat back duct (A) after loosening the mounting screws.

9.
Disconnect the front seat lower connectors (A).

10.
Disconnect the fixing hook (A) from the front seat back lower.

11.
Disconnect the protector (A) from the front seat back frame.

12.
Turn the front seat back cover inside out. Then pull out the headrest guides (A) while pinching both sides of the lower part of the guides.

13.
Remove the front seat back cover (A) from the front seat back frame.

14.
After removing the velcro tape (A) and hog-ring clips (C) on the front of seat back, remove the front seat back cover (B).

15.
Install in the reverse order of removal.
   
•
Make sure that the connectors are plugged in properly.
•
Replace any damaged clips.
•
To prevent wrinkles, make sure that the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool [09880-4F000].

Front Seat Back Cover Components and Components Location
Component Location 1. Front seat back cover ...

Front Seat Cushion Cover Components and Components Location
Component Location 1. Front seat cushion cover ...

Other Information:

Sunroof Assembly Repair procedures
Replacement     Put on glove to protect your hands.     Take care not to scratch the interior trims and other parts. 1. Remove the roof t ...

Compression Test
Compression Pressure Inspection     If there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up the engine t ...

Categories

Copyright © www.kisedona.com 2016-2026