Kia Optima Manuals

Kia Sedona: Center Fascia Panel Repair procedures - Crash Pad - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Center Fascia Panel Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Crash Pad / Center Fascia Panel Repair procedures

Replacement
[Center fascia upper panel]
   
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Lower the steering wheel.
2.
Using a screwdriver or remover, remove the center fascia upper panel (A).

3.
Disconnect the start/stop button connector (A).

4.
Install in the reverse order of removal.
[Center fascia lower panel]
   
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the crash pad lower panel.
(Refer to Crash Pad - "Center Fascia Panel ")
2.
Loosen the mounting screws and remove the center fascia lower panel (A).

3.
Disconnect the controller connector (A).

4.
Install in the reverse order of removal.
Center Fascia Panel Components and Components Location
Component Location 1. Center fascia upper panel2. Center fascia lower panel ...

Crash Pad Lower Panel Components and Components Location
Component Location 1. Crash pad lower panel ...

Other Information:

Output Speed Sensor Description and Operation
Description • Output speed sensor uses an electric current type hall sensor in which the current is changed by the magnetic variation. • Output speed sensor (A) and input speed ...

Ambient Temperature Sensor Description and Operation
Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower te ...

Categories

Copyright © www.kisedona.com 2016-2025